Type 25 Other Switches

Illuminated steel starter  to fit all vehicles, especially Buggies, Trikes and Kit Cars Quality: Good quality reproduction   Fitting: 12 volt, 50amp max , 21mm aperture...

Period looking stainless steel starter or horn button to fit all vehicles, especially Buggies, Trikes and Kit Cars Quality: Good quality reproduction   Fitting:...

These push buttons are ideal for use as a starter,horn or electric washer button.

Replacement Hall Impulse Sender for use on all Type 25 (T3) Buses from 1979 to 1992 and all 1.8 Mk1 Golf GTI Cabriolet`s with a Bosch distributor.

PLEASE NOTE For T3 or Type 25s the connector may need to be retained from your existing sender, this may involve cutting and soldering

Oil pressure switch. Located in the flexible power steering hose. Special Order please call for lead time.

This boot sits between the intake and airflow meter on buses with 1900cc DH and GW engine codes and 2100cc DJ engine codes with injection.

Do you have holes in your dash with no switches in?

Not all switches were fitted into every model.  Sometimes they were fitted with plastic blanks.

If this is the case for you then this blank might be just what you have been searching for.

Thermo switch for the intake manifold heating on Type 25 Syncro Buses with 1.6 Turbo Dioesel Engines (JX Engine Code) which have an additional water pump.

2 Pin switch which opperates at 97c and 104c.

Either Orange and/or black and yellow in colour.

20mm Diameter.

Fits models from chassis number F 24-K-064 851 onwards.

Heater blower resistor including wiring harness for use on all Type 25 (T3) Buses, Mk1 Golf`s, Mk2 Golf`s, Mk1 Golf Cabriolet`s, Caddy`s, Scirocco`s and Jetta`s.

Fits both left and right hand drive cars.

Sliding door contact switch for Type 25 (T3) Buses from October 1984 onwards that are fitted with central locking.