Shop by Product > Suspension + Steering Products > Aftermarket Front Suspension Products > Front Beam Adjusters

Type 1 sway-a-way front beam adjuster 1965-1979 linkpin vehicles. Make your exsisting beam adjustable. Requires removal and dismantling of the front beam, cut and weld in 2 adjusters (top and bottom). Will raise or lower your beam by upto 4". NOTE: 2 needed per car.

Type 1 sway-a-way front beam adjuster >1965 linkpin vehicles. Make your exsisting beam adjustable. Requires removal and dismantling of the front beam, cut and weld in 2 adjusters (top and bottom). Will raise or lower your beam by upto 4". NOTE: 2 needed per car.

Avis style adjuster for T1 1966 - 1979.

Make your T1 beam into an adjustable beam with four inches of adjustment when on the vehicle. Welding and the stripping down of your beam is required.

NOTE: You will need two of these kits to complete one front beam.

Type 2 Front Beam Adjusters >1967. Sold in kits to do one beam. Requires removal and dismantling of your front beam and then the adjusters are cut and welded into each tube allowing you to raise or lower the front of your Bus by around 4".

Albatross Adjuster Kit T2 >67

Castor shims for T1 front beam. Made from ultra strong aluminium these shims improve the geometry of the front beam when really lowering the car. Long bolts must be used when using more than 1 pair of shims. Sold in Pairs

This metal block is used on all Sway Away beam adjusters and Avis Style Beam adjusters.

It sits inside the front beam and the torsion leaves go through the centre of it.

This nut is used on all Sway Away beam adjusters and Avis Style Beam adjusters.

It screws onto the stud that screws into the aluminium block holding the leaves in place to the adjuster.

This stud is used on all Sway Away beam adjusters and Avis Style Beam adjusters.

It screws into the aluminium block holding the leaves in place to the adjuster.

Avis style adjuster for T1  up to 1965.

Make your T1 beam into an adjustable beam with four inches of adjustment when on the vehicle. Welding and the stripping down of your beam is required.

NOTE: You will need two of these kits to complete one front beam.

This stud is used on all Sway Away beam adjusters and Avis Style Beam adjusters.

It screws into the aluminium block holding the leaves in place to the adjuster.

This stud is used on all Sway Away beam adjusters and Avis Style Beam adjusters.

It screws into the aluminium block holding the leaves in place to the adjuster.